Black & Decker KC360NM Manual page 7

This appliance is not intended for use by young or infirm persons without supervision.

Children must be supervised to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised

Black & Decker Service Centre in order to avoid a hazard.
Overview
1. On/off switch
2. Forward/reverse slider
3. Bit holder
Fig. A
4. Charger
5. Charger plug
6. Charger connector
Assembly
Fitting and removing a screwdriver bit (fig. B)
This tool uses screwdriver bits with a 6.35 mm (1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).

To remove a bit, pull the bit shaft out of the bit holder (3).

se
U
Before first use, the battery must be charged for at least 16 hours.

Charging the battery (fig. A)
To charge the battery, insert the charger plug (5) into the connector (6).

Plug in the charger (4).

Switch on at the mains.
Leave the tool connected to the charger for 8 - 10 hours.

The charger may hum and become warm while charging; this is normal and does not
indicate a problem.
Generally, a charging time of 8 hours will enable the tool to operate at an effective power
level for most tasks. However, further charging for up to 10 hours could significantly increase
the run time, depending on the battery and charging conditions.
Before using the tool, unplug the charger and disconnect the tool from the charger.

ENGLISH
7