Video Problems - Fujitsu Lifebook S7110 User Manual

S7110.book Page 63 Monday, March 20, 2006 1:56 PM
Problem
The Suspend/Resume There may be a conflict with
button does not work. the application software.
(continued)
The system powers up, and The boot sequence settings
displays power on informa- of the setup utility are not
tion, but fails to load the compatible with your
operating system. configuration.
You have a secured system
requiring a password to load
your operating system.
Internal hard drive was
not detected.
An error message is Power On Self Test (POST) has
displayed on the screen detected a problem.
during the notebook
(boot) sequence.
Your notebook appears to BIOS setup changes were not
change setup parameters saved when you made them
when you start it. and exited the BIOS setup
utility returning it to
previous settings.
The BIOS CMOS hold-up
battery has failed.
Your system display won't The system may be password-
turn on when the system is protected.
turned on or when the
system has resumed.

Video Problems

The built-in display is Something is pushing on the
blank when you turn on Closed Cover switch.
your LifeBook notebook.
The notebook is set for an
external device only.
The angle of the display and
the brightness settings are not
adequate for your lighting
conditions.
Possible Cause
Close all applications and try the button again.
Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu. (See BIOS Setup
Utility on page 29 for more information)
Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly. (See BIOS Setup Utility
on page 29 for more information)
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
See the Power On Self Test (POST) messages to
determine the meaning and severity of the problem.
Not all messages are errors; some are simply status
indicators. (See Power On Self Test Messages on
page 66 for more information)
Make sure you select Save Changes And Exit when
exiting the BIOS setup utility.
Contact your support representative for repairs.
This is not a user serviceable part but has a normal
life of 3 to 5 years.
Check the status indicator panel to verify that the
Security icon is blinking. If it is blinking, enter your
password.
Clear the Closed Cover switch. (See figure 2-4 on
page 6 for location)
Pressing [F10] while holding down the [Fn] key
allows you to change your selection of where to
send your display video. Each time you press the
combination of keys you will step to the next
choice. The choices, in order are: built-in display
only, external monitor only, both built-in display
and external monitor.
Move the display and the brightness control until
you have adequate visibility.
T r o u b l e s h o o t i n g
Possible Solutions
63