Memory Problems; Problem; Modem Problems; Parallel, Serial And Usb Device Problems - Fujitsu Lifebook S7110 User Manual

S7110.book Page 60 Monday, March 20, 2006 1:56 PM
L i f e B o o k S 7 1 0 0 N o t e b o o k

Problem

You have installed an Your operating system soft-
external keyboard or ware is not set up with the
mouse, and it does not correct software driver.
seem to work.
(continued)
You have connected an Your operating system soft-
external keyboard or a ware is not set up with the
mouse and it seems to be correct software driver for that
locking up the system. device.
Your system has crashed.

Memory Problems

Your Power On screen, or Your memory upgrade module
Main menu of the BIOS is not properly installed.
setup utility information,
does not show the correct
You have a memory failure.
amount of installed
memory.

Modem Problems

Messages about modem Messages about modem
operation. operation are generated by
whichever modem application
is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel The device is not properly
port device, a serial port installed.
device or a USB device.
The device may have been
Your LifeBook notebook
installed while an application
does not recognize the
was running, so your notebook
device, or the device does
is not aware of its installation.
not seem to work properly.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
Parallel port is set to output
only.

PC Card Problems

A card inserted in the PC The card is not properly
Card slot does not work or inserted.
is locking up the system.
60
Possible Cause
Check your device and operating system docu-
mentation and activate the proper driver.
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 66 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 52 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-insert the card. (See PC Cards/
ExpressCards™ on page 43 for more information)
Possible Solutions