Radio - Intelicis Cedar 880AG User Manual

Specify the MAC authentication profile to be used for authentication. You must
have already configured a MAC authentication profile in the system. If the MAC
authentication method requires the RADIUS Server, you will also need to specify
the RADIUS profile.
RADIUS Profile
Specify the RADIUS profile to be used for 802.1x or MAC authentication.
Forced Unicast Tx Rate
This parameter allows you to configure a transmission rate (in 100 kbps) that will
be used for all unicast frames. The rate must be one of the AP's supported rates.
Maximum Unicast Tx Rate
This parameter allows you to set a maximum limit on the transmission rate to be
used. By default, this option is disabled, which allows any supported rate to be used.
Min Rate to Associate
This parameter allows you to set a minimum rate required for association. If a client
station does not support any rates equal to or greater than this rate, the association
will be rejected.
DTIM
The Delivery Traffic Indication Message (DTIM) is used by the AP to indicates
which client station, currently sleeping in low-power mode, have data buffered on
the access point waiting for pick-up. DTIM should be left at 2, the default value.
This parameter supports a range between 1 and 255.
Maximum Stations
This parameter specifies the maximum number of stations which can associate with
the AP. The default is 256.

7.2.3 Radio

Select Wireless->Radio 1 or Wireless->Radio 2 to display radio specific parameters for
radio 1 or 2. Except for WLAN and Bridge Link, most of the parameters can be left with
their default values.
Cedar 880AG Enterprise Dual-Radio AP/Bridge
51