Table of Contents
Advertisement
2.3
Install the Unit
2.3.1 Mounting Options
The Cedar 880AG is designed with two installation options:
• On desktop or shelf
• Wall mount
Mounting Cedar 880AG on desktop or shelf:
• Adhere the 4 mounting rubber feet to the bottom of the unit.
• Place the unit on a secure, flat surface.
Mounting Cedar 880AG on wall:
• At desired wall location, position nails to match the wall mount holes on the bottom
of the unit.
• Secure unit firmly on the nails.
2.3.2 Supplying Power to the Unit
The Cedar 880AG is equipped with a universal 100-240 VAC, 50/60 Hz power supply.
To power the unit, connect the included power adaptor to the wall outlet and plug the DC
output connector into the power jack on the rear panel of Cedar 880AG.
Cedar 880AG also supports the 802.3af PoE standard. If your switch or gateway has the
capability to supply PoE to remote devices, simply connect the Ethernet cable from your
switch or gateway to the RJ45 connector on the rear panel of Cedar 880AG. This will
automatically supply power to the unit.
2.4
Connecting Cedar 880AG
To establish a connection to Cedar's console interface, you will need to:
• Connect a regular straight serial cable to the console port located on the rear panel of
the unit.
• Connect the other end of the serial cable to a terminal or PC.
After the unit is turned on, the LEDs on the top panel will follow the pattern described
below:
• The Power LED goes on.
• The Ethernet LED will be ON if the Ethernet port is connected to a switch or gateway
and a valid link is established.
• After 30 seconds, the 802.11a and 802.11g LEDs will be flashing.
Cedar 880AG Enterprise Dual-Radio AP/Bridge
14
Advertisement
Table of Contents
