Honda ADV150 2019 Owner's Manual page 125

Unlock the Ignition Switch in an Emergency
ID number input success
After the last ID number is inputted, through,
the ignition switch ring and Honda SMART
Key Indicator will flash every 2 seconds until
the EM mode coupler is removed.
Be sure to remove the EM mode coupler and
return the blue dummy coupler. Buzzer rings 2
times when the EM mode coupler was removed.
The ignition switch is then unlocked. Reinstall the
parts in reverse order of removal and turn the
ignition switch to the (On) position within 6
minutes. You can start the engine.
To lock the ignition switch, turn the ignition switch
to the SEAT FUEL,
and press and hold the ignition switch for 2
seconds. Buzzer rings 1 time. The ignition switch
also locks automatically when the ignition switch
has been in the SEAT FUEL,
position for about 6 minutes after the ID number
is successfully inputted.
When the ignition switch is locked, the ignition
switch ring goes off.
120
(Off), or (Lock) position,
(Off), or (Lock)
To unlock the ignition switch again, repeat the
procedure for unlocking the ignition switch.
ID number input failure
After the last ID number is inputted, the
ignition switch ring and Honda SMART Key
Indicator will flash every second until the EM
mode coupler is removed, and the ignition
switch cannot be unlocked.
Pull out the EM mode coupler and reconnect
it to the EM mode connector. Follow the
procedure again. P. 119
2
ID number input cancel
Pull out the EM mode coupler from the EM
mode connector.
Also, if you make a mistake while inputting the
ID number, remove the EM mode coupler from
the EM mode connector, connect it to the EM
mode connector again, and then re-input the
ID number from the beginning.
Store the removed EM mode coupler in
●
the tool kit at all times.