How To Operate Your Ceiling Fan - Fanimation BECKWITH FP7964BN Installation Instructions Manual

IMPORTANT:
1. Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3. To make fan operational, install two 3-volt batteries
(included) in the hand-held remote transmitter. If not
using for long periods of time, remove battery to prevent
damage to transmitter. Store the remote away from
excessive heat or humidity. (Figure 3)
4. The 5-button hand-held remote transmitter includes
buttons for high, medium and low fan speeds as
well as fan off and light on/off. (Figure 4)
5. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Slide the reverse switch on top of motor assembly
to the opposite position and turn fan on again. (Figure 5)
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise

How to Operate Your Ceiling Fan

Switch Position
Right
Left
For illustrative purposes only-not
intended to cover all types of controls
3V, CR2032
BATTERY
2 PCS
REMOTE
CONTROL
5-BUTTON
REMOTE
CONTROL
Reverse
Switch
12
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3
Figure 4
Figure 5