Disassembly Procedure For Main Board - TC Electronic Finalizer Epress Technical & Service Manual

Disassembly Procedure for Main Board

1. Turn Off Power and Disconnect Power Cord.
2. Loosen 5 screws, see fig. 1, and remove the top cover.
3. Disconnect front connector, J1, see fig. 2.
4. Remove screws at MT7, MT8, MT2 on the main board, see fig. 2.
5. Remove 9 screws at the XLR connectors on the back panel, see fig. 3.
6. Remove the screw at the SPDIF in/out connector, see fig. 3.
7. Remove the screws at the ADAT in/out connector, see fig. 3.
8. Remove the jack nut at the EXT. CONTROL IN connector, see fig. 3.
9. Push the main board into the front profile a little to free the connectors from
the back panel, then lift out the board.
10. Desolder the wires from power supply - see fig. 7.
Fig. 3: Screws at back panel.
0
PROFESSIONAL
AUDIO EQUIPMENT
100-240VAC / 20W LISTED
5D83
3 screws
______________________________________________________________________________________________________________________________________________________________________________
_________________
TC Electronic A/S
BALANCED INPUTS
BALANCED OUTPUTS
LEFT RIGHT LEFT RIGHT
PIN2+/PIN3- PIN2+/PIN3-
[mono]
3 screws
Fig. 1: Screws at top lid
Fig. 2: Screws and front connector at main board
DI DO
OPTO
SERIAL NO.
2 screws
Finalizer Express Service manual
Top view
5 screws
Top view
main board
J1
MT7 MT8 MT2
DIGITAL AUDIO
DI DO IN
DI
DO
AES/EBU SP/DIF
1 screw
3 screws
Power
Supply
MIDI / RS485 EXTERNAL
CONTROL
THRU OUT
IN
Jack nut
page 7