Broadcastvision Entertainment AudioFetch Express User Manual page 9

o You will need to reconnect your PC/device to the AFE via the new
networking mode, in order to re-establish access to the Doghouse
(just like starting from scratch)
 Any mistake made in the settings, could cause the AFE to become
inaccessible after the "Save Settings" button is clicked.
 For any problem, best course of action is:
o Use the red User Button to restore factory defaults in the Wi-Fi
Module. (This process is described in the next section)
o Reconnect to the default AFE Access Point (SSID:AudioFetchExpress)
o Access the Doghouse
o Start over again entering the desired new network
configuration settings The general steps to reconfigure the
network mode through this Doghouse page are:
1. Connect to the AFE and access the Doghouse via the AFE's current
networking mode
a. In Access Point mode: Access the Doghouse through the AFE's Wi-
Fi network
b. In Access Point & Wireless Internet mode: Access the Doghouse
through the AFE's Wi-Fi network
c. In Wireless Client mode: Access the Doghouse through the
existing Wi-Fi network
d. In Wired Only mode: Access the Doghouse through the existing
Wi-Fi network
2. If for some reason the Doghouse page comes up showing "unspecified"
for the Networking Mode, it means the settings have not been read in yet
from the Wi-Fi module
a. This would typically only occur if you've just powered-on the AFE
and managed to connect to the Doghouse very quickly
b. The module settings are read-in approximately 20 seconds after the
module is booted up – reason for this is to allow the module time to
connect to the existing network (in Client Mode for example) in order
to set the current Wi-Fi channel
c. If this situation ever occurs, just wait a few seconds and then click
the "Restore" button, the settings will refresh within a few seconds.
If not, then try again. If still not then power-cycle the AFE.
3. Adjust the desired settings
a. Nothing on this page is activated or saved until the "Save Settings"
button is clicked
4. Carefully review the settings
5. Click the "Save Settings" button
6. Review the warning dialog that pops up
7. Click the "OK" button in the warning dialog – this will:
9