Broadcastvision Entertainment AudioFetch Express User Manual page 10

a. Cause the Status LEDs to begin a "marching" pattern to indicate the
save is still in- progress. The march will be: yellow, green, red,
repeat....
b. Save the new settings (they will survive subsequent power cycles)
i. The save will take some time in the module, the LEDs will
c. Then, both AFE and Module will be rebooted
8. After the reboot, the new networking mode should be active
9. If any problem after the reboot (ie: new networking mode doesn't seem
to work), then first thing to try is a power cycle.
This Doghouse page is designed to be as foolproof as possible:
 Only those settings applicable for the selected Networking Mode will be
available for editing (automatically grayed out if not applicable)
 Once any setting is changed, a warning notice will appear that the new
settings have not been saved. This warning will persist until one of the
following occurs
o Restore button is clicked
o Save Settings button is clicked and OK is clicked in the warning
dialog
 There is a "Restore" button that undoes all the changes
 A warning dialog will automatically display if the Save Settings button is
clicked and any required settings are missing
o For example:
entered
Note: The Restore button does a bit more (behind the scenes) than just undo
any changes entered on the Doghouse page. It actually performs a full re-read
of all configuration settings from the module. So this can be considered a full
"refresh" of the displayed info. Mainly this is useful to re-read the current Wi-Fi
channel being used, especially when the AFE is operating in Client Mode.
continue marching
if encryption has been enabled but no password
10