Edit To Or From Another Video Recorder - JVC HR-XVS30E Instructions Manual

Edit To Or From Another
Video Recorder
You can use your unit as the source player or as the
recording deck.
A When using your unit as the source player:
Player
TV
AV mode
21-pin SCART cable
(not provided)
Recorder
B When using your unit as the recording deck:
TV Recorder
AV mode
21-pin SCART cable
(not provided)
Player
Slide the TV/VCR/DVD switch to the right.
A
Make connections.
Connect the player's 21-pin SCART connector to the
unit's 21-pin SCART connector as illustrated.
A When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording
deck.
B When using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER
connector to the source player.
● If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set "L-1
OUTPUT" to "S-VIDEO". (
— when using your unit as the recording deck, set "L-2
INPUT" to "S-VIDEO". (
Your unit
Another recorder
Your unit
Another recorder
pg. 56)
pg. 57)
B
Select the S-VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
C
Set the input mode of recording deck.
With this unit, press AUX (number key "0") and/or PR to
select "L-1" for the L-1 IN/OUT connector, or "L-2" for
the L-2 IN/DECODER connector, depending on the
connector being used.
● When using another recorder as the recording deck, refer to its
instruction manual.
● When using the L-2 IN/DECODER connector, set "L-2
SELECT" to "A/V". ( pg. 57)
D
Set the edit mode.
See "PICTURE CONTROL" on page 65.
E
Engage the Record Pause mode of the
recording deck.
Locate the point where you start recording, then engage
the Record Pause mode.
F
Start the source player.
Engage the Play mode of the source player.
G
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
● All necessary cables can be obtained from your dealer.
● For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
● When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
● When you use this unit as the source player for editing, be sure
to set "O.S.D." to "OFF" before starting. (
● If you are using another recorder with S-Video and Audio
output connectors, connect its S-Video and Audio output
connectors to this unit's front panel S-VIDEO and AUDIO
input connectors. Then, set the unit's input mode to "S-1" in
step C.
55
EN
pg. 65)