Edit To Or From Another Video Recorder - JVC HR-S7600AM Instructions Manual

Edit To O r
From Another
V ideo
Recorder
TV Receiver
VIDEO
CHANNEL
RF Cable (provided)
Recorder
AV Cable
(not provided)
Another recorder
Player
IM PO RTAN T:
● To edit, both the player and the recorder must be of the
same colour system. Press your recorder's CO LO U R
SYSTEM button to select the appropriate colour system.
● For more information on multi-system compatibility,
pg. 50.
Downloaded from: https://www.usersmanualguide.com/
Player Your recorder
AV Cable
(not provided)
Another recorder
Recorder
Your recorder TV Receiver
RF Cable
(provided)
You can use your video recorder as the source player or the
recording deck.
MAKE CO N N ECTIO N S
1
Connect the player's AUDIO/VIDEO OUT connectors
to the recorder's AUDIO/VIDEO IN connectors.
● Use the L connector for monaural connection.
SET RECO RDIN G DECK' S
IN PUT MO DE
2
Set to AUX. With this video recorder, press N U M BER
key "0" and/or TV PRO G to select depending on the
connector being used — "L-1" for the rear panel VIDEO/
AUDIO input connectors, or "F-1" for the front panel
VIDEO/AUDIO input connectors.
SET EDIT MO DE
3
See "Picture Control" on page 38.
ST ART SO URCE PLAYER
4
Engage its Play mode.
ST ART RECO RDIN G DECK
5
Engage its Record mode.
N O TES:
● When you use this recorder as the player for editing, be sure
to set "O.S.D." to "OFF" before starting (
● All necessary cables can be obtained from your dealer.
● NTSC tapes being played back in the NTSC [ PAL mode
( pg. 51) cannot be dubbed to another recorder.
● When you dub an NTSC tape using your recorder as the
playback deck, select NTSC 3.58 (or NTSC 4.43) with the
CO LO U R SYSTEM button (
● When you select EDIT to dub tapes in step
VIDEO
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish
CHANNEL
dubbing the tapes (
● If you are using another recorder with S-Video and Audio
input/output connectors, you can connect those connectors to
this recorder's S-VIDEO and AUDIO input/output connectors.
When Using Your Video Recorder As The Source Player ...
... connect its rear panel S VIDEO OUT and AUDIO OUT
connectors to the recording deck's S-Video and Audio input
connectors.
When Using Your Video Recorder As The Recording Deck ...
... connect its front panel S-VIDEO and AUDIO input
connectors to the source player's S-Video and Audio output
connectors. Then, set the recorder's input mode to "S-2".
O R
... connect its rear panel S VIDEO IN and AUDIO IN
connectors to the source player's S-Video and Audio output
connectors. Then, set the recorder's input mode to "S-1".
EN
pg. 10).
pg. 50).
3 , be sure to select
pg. 38).
41