Operating Your Lifebook Security Application Panel; Operating Your Lifebook; Security Application Panel - Fujitsu Lifebook E6150 User Manual

L i f e B o o k E S e r i e s – S e c t i o n T w o
Setting Passwords
When shipped from the factory, no passwords are set.
You have a choice of having no password or setting a
supervisor and user password. You must set the super-
visor password before the user password.
P O I N T
The purpose of supervisor password is to be able to
bypass the user password in case the user password is
forgotten. The supervisor password alone will not lock
the system.
P O I N T
You have to set both the supervisor and user passwords
for the security panel to work.
Setting Supervisor Password
You must have set a supervisor password before setting
any user passwords. The supervisor password can bypass
the user password.
1. Go to the Start menu.
2. Click on Run.
3. Type in FJSECS.EXE, then press [Enter]
4. Follow the on-screen instructions to set the
Supervisor password.
Setting User Password
1 Go to the Start menu.
2. Click on Programs.
3. Click on Security Panel Application and
Set User Password.
4. Follow the on-screen instructions to set the
user password.
P O I N T
You may change or remove the supervisor or user
password by repeating the steps defined above.
30

OPERATING YOUR LIFEBOOK

SECURITY APPLICATION PANEL

The security lock feature is in effect both when the system
resumes from OFF or suspend state. You would always
need to push the Suspend /Resume button to input the
user password. Your system will not begin the boot
sequence without entering your supervisor/user pass-
word.
From Off State
1. Turn on your system.
2. When Lock Indicator LED lights up, enter the pass-
word and press Enter button.
For example, if the password is 22222,
Press Button Number 2 five times and press Enter
button.
The LifeBook will boot to normal operation.
From Suspend State
1. Press your Suspend/Resume button.
2. When Lock Indicator LED lights up, enter the pass-
word and press Enter button.
The LifeBook should resume normal operation.
Incorrect Password Entry
If an invalid supervisor or user password is entered three
times in succession, the system will "beep" for about one
minute. If a valid password is entered within a minute
(while system beeps), the beeping will stop and the Life-
Book will resume normal operation. If no or invalid
password is entered while the system beeps, the system
will return to its previous locked state (suspend or off)
and the Lock Indicator LED will go off. To reactivate the
LifeBook after a password failure, you must press the
Suspend/Resume button, then enter a correct password.
P O I N T
Remember the user password you specified on the
Security Panel Application. If you forget the password
you will not be able to use your computer. The super-
visor password can override the user password.