Fujitsu Lifebook E6150 User Manual page 85

Problem
Memory Problems
Your Power On screen,
or Main menu of the
BIOS setup utility infor-
mation, does not show
the correct amount of
installed memory.
Modem Problems
Messages about modem
operation.
Parallel, Serial, and USB Device Problems
You have installed a parallel
port device, a serial port
device or a USB device.
Your LifeBook does not
recognize the device, or the
device does not seem to
work properly.
Possible Cause
Your memory upgrade module
is not properly installed.
You have a memory failure.
Messages about modem
operation are generated
by whichever modem
application is in use.
The device is not
properly installed.
The device may have been
installed while an application
was running, so your LifeBook
is not aware of its installation.
Your software may not have
the correct software driver
active.
You may have the wrong
I/O address selected for
your device.
Your device and another
device are assigned the same
I/O address.
Parallel port is set to
output only.
T r o u b l e s h o o t i n g
Possible Solutions
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 65
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 81 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 67 for more information)
Close the application and restart your LifeBook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 41 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
75