Removing Pc Cards - Fujitsu Lifebook E6150 User Manual

L i f e B o o k E S e r i e s – S e c t i o n F o u r
4. Push the card into the slot firmly until it is seated
in the opening. You will hear a click and the Eject
button will pop away from your LifeBook.
5. Flip the Eject button towards the front of
your LifeBook.
6. Lock the PC Card into the slot by sliding the
Lock button toward the front of your LifeBook.

REMOVING PC CARDS

To remove a PC Card, perform the following steps:
C A U T I O N
Windows 98 Second Edition has a shutdown procedure
for PC Cards that must be followed before removing a
card. Review your operating system manual for
the correct procedure.
Windows 2000 Professional PC Cards should be
stopped using the Unplug or Eject Hardware utility on
the taskbar. Refer to your operating system manual for
the correct procedure.
1. See your PC Card manual for specific instructions
on removing your card. Some PC Cards may require
your LifeBook to be Off while removing them.
64
P O I N T
If the dialog box states that the device cannot be
removed, you must save all of your open files, close
any open applications and shut down your LifeBook.
Once your LifeBook has been shut down, you must turn
Off the power using the power switch.
2. Unlock the PC Card from the slot by sliding the
Lock button toward the rear of your LifeBook.
3. Flip the Eject button towards the rear of your Life-
Book until it is fully extended, and then push it in
until it is flush with the LifeBook. This will push the
PC Card slightly out of the slot allowing you to
remove the card.
C A U T I O N
If the PC Card has an external connector and cable, do
not pull the cable when removing the card.