Advertisement
Advertisement
Table of Contents
Related Manuals for EURO EP900UMS
Summary of Contents for EURO EP900UMS
- Page 1 EP900UMS...
-
Page 2: Table Of Contents
CONTENT 2……………………………………….Notice 3………………………………………..Installation 3…………………………………………Use 4………………………………………..Notice of installation 4………………………………………..Safety Warning 5…………………………………………Maintenance 7…………………………………………Abnormity and Solution... -
Page 3: Notice
NOTICE 1. Thank you for choosing our cooker hood. Please read the instruction manual carefully before use. 2. The installation work must be undertaken by a qualified and competent fitter. 3. The manufacturer disclaims all liability for any damage or injury caused as a result of not following instructions for installation contained in the following text. - Page 4 (1) INSTALLATION 1. The cooker hood should be placed at a distance of 65- 75cm (26-30inch) from the cooking surface for the best effect. 2. Drill a hole in the cupboard, with hole wide 490*265 (mm). Make sure it’s at least 35mm from the edge of the hole to the cupboard edge.
-
Page 5: Notice Of Installation
Explain the instructions: a. Connection of the appliance to the supply mains. b. Necessity to allow disconnection of the appliance from the supply after installation. Disconnection may be achieved by having the plug accessible or by incorporating a switch in the fixed wiring in accordance with the wiring rules. -
Page 6: Maintenance
CAUTION: Accessible parts may become hot when used with cooking appliances. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Page 7 6. Activated carbon filter can be used to trap odors. In order to install the activated carbon filter, user have to unscrew and take down the front panel. Then plug the activated carbon filter into the unit and turn it in anti-clockwise direction. Repeat the same on the other side. NOTE: Make sure the filter is securely locked.
-
Page 8: Abnormity And Solution
(6) ABNORMITY AND SOLUTION Fault Cause Solution The bulb damaged Change bulb Light does not work, Bulb contact lamp cap bad Fix or change but motor work Light panel switch damage Fix or change Bulb contact lamp cap Restart later Motor bearings damage Change motor Light work, but...
Need help?
Do you have a question about the EP900UMS and is the answer not in the manual?
Questions and answers