Related Manuals for Makita M9507
Summary of Contents for Makita M9507
- Page 1 INSTRUCTION MANUAL Angle Grinder M9506 M9507 M9508 DOUBLE INSULATION Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: M9506 M9507 M9508 Wheel diameter 100 mm 115 mm 125 mm Max. wheel thickness 4 mm 6.4 mm Spindle thread M10 x 1.5 M14 x 2 Rated speed (n)/ No load speed (n 11,000 min Overall length 261 mm Net weight 1.6 kg... -
Page 3: Grinder Safety Warnings
When operating a power tool outdoors, use an Maintain power tools. Check for misalignment extension cord suitable for outdoor use. Use of or binding of moving parts, breakage of parts a cord suitable for outdoor use reduces the risk of and any other condition that may affect the electric shock. - Page 4 The wheel may either jump toward or away from the accessory is dropped, inspect for damage or install an undamaged accessory. After inspect- operator, depending on direction of the wheel’s move- ing and installing an accessory, position your- ment at the point of pinching. Abrasive wheels may also self and bystanders away from the plane of break under these conditions.
-
Page 5: Functional Description
Additional Safety Warnings: FUNCTIONAL When using depressed centre grinding wheels, be sure to use only fiberglass-reinforced DESCRIPTION wheels. NEVER USE Stone Cup type wheels with this grinder. This grinder is not designed for these CAUTION: Always be sure that the tool is types of wheels and the use of such a product switched off and unplugged before adjusting or may result in serious personal injury. - Page 6 Installing or removing depressed ASSEMBLY center wheel CAUTION: Always be sure that the tool is Optional accessory switched off and unplugged before carrying out any work on the tool. WARNING: When using a depressed center wheel, the wheel guard must be fitted on the tool Installing side grip (handle) so that the closed side of the guard always points toward the operator.
-
Page 7: Grinding Operation
Grinding operation Makita Authorized or Factory Service Centers, always using Makita replacement parts. Turn the tool on and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc at an angle of about 15°... - Page 8 Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 885527-934 20160629 www.makita.com...