Table of Contents
Advertisement
8. Install the 2.5-inch secondary storage drive.
9. Install the 2.5-inch secondary storage drive with the bracket.
10. Connect the signal cable and the power cable to the new 2.5-inch secondary storage drive on the
bottom of the drive bay assembly.
11. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
M.2 solid-state drive and heat sink
Prerequisite
Before you start, read Appendix A "Important safety information" on page 73 and print the following
instructions.
The heat sink might be very hot. Before you open the computer cover, turn off the computer and wait several
minutes until the computer is cool.
Attention:
.
Chapter 7
CRU replacement
53
Advertisement
Table of Contents
