Table of Contents
Advertisement
2. Remove the 2.5-inch primary storage drive from the storage converter.
3. Install the 2.5-inch primary storage drive to the storage converter.
4. Connect the signal cable and the power cable to the new 2.5-inch primary storage drive on the bottom
of the drive bay assembly.
5. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
2.5-inch secondary storage drive
1. Remove the computer cover. See "Computer cover" on page 43.
2. Remove the front bezel. See "Front bezel" on page 44.
3. Remove the optical drive, if any. See "Optical drive" on page 45.
4. Remove the drive bay assembly. See "Drive bay assembly" on page 47.
.
Chapter 7
CRU replacement
51
Advertisement
Table of Contents
