M.2 Solid-State Drive And Heat Sink - Lenovo 30FM002VUS User Manual

M.2 solid-state drive and heat sink

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
• Do not apply pressure to the internal storage drive.
• Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on a soft material, such as cloth, to absorb physical shocks.
Removal steps of the M.2 solid-state drive Gen 4
• Remove the "Computer cover" on page 32.
• Remove the "2.5-inch primary hard disk drive, bracket, and cage" on page 36.
• Remove the M.2 solid-state drive and the heat sink (if any) depending on the computer model.
– For computers without the heat sink for the M.2 solid-state drive:
48
P360 Tower User Guide