Electrical Connection - Miele H 7780 BP2 Operating And Installation Instructions

Installation

Electrical connection


Risk of injury due to electric
shock.
During installation, maintenance, and
repair work, the oven must be
completely disconnected from the
power supply:
Disconnect the oven from the power
supply by tripping the breakers, or
unplugging the power cord from the
outlet. To do this, pull the plug not
the cord.

Risk of injury.
Installation, repairs, and other work
by unqualified persons could be
dangerous. Miele cannot be held
liable for unauthorized work.
Installation, maintenance, and repairs
must only be carried out by a Miele
authorized technician.
The connection data (voltage and
frequency) on the data plate of the
oven must match the power supply
in order to avoid the risk of damage
to the oven.
Compare this before connecting the
appliance to the power supply. If in
any doubt, consult a qualified
electrician.
For safety reasons, the oven may
only be used when it has been fully
installed.
The power cord plug must be inserted
into a suitable outlet that has been
installed and grounded in compliance
with all applicable local codes.
116
WARNING: THIS APPLIANCE MUST
BE GROUNDED
Installer: Please pass these
instructions on to the customer.
Electrical connection
The oven is equipped with a power cord
approx. 6 ft (1.8 m) long with a 4-pin
NEMA 14-50P plug for connection to a
power supply with:
- 2NAC 208 V, 50 A, 60 Hz
or
- 2NAC 240 V, 50 A, 60 Hz
Temporary or permanent operation on
an autonomous power supply system or
a power supply system that is not
synchronized with the grid power
supply (e.g., island networks, back-up
systems) is possible. A prerequisite for
operation is that the power supply
system complies with the specifications
of EN 50160 or an equivalent standard.
The function and operation of the
protective measures provided in the
domestic electrical installation and in
this Miele product must also be
maintained in isolated operation or in
operation that is not synchronized with
the grid power supply, or these
measures must be replaced by
equivalent measures in the installation.
As described, for example, in the
current version of VDE-AR-E 2510-2.
You can set the voltage variant (see
"Settings – Electrical version").
KEEP THE OPERATING AND
INSTALLATION INSTRUCTIONS IN A
SAFE PLACE.