Care - Electrolux ECH/AT-1701 3AI-W MG EEC User Manual

8
www.home-comfort.com
100 mm
min.
1. Wall mounted installation option
(bracket and mounting template
included)
Use the brackets to mount the heater on
the wall according to the pictures below.
The distance from the device to the floor
and surrounding objects must be at least 10
cm (Figure 5):
To install the bracket on a wall, follow these
steps:
• Attach the mounting template to the wall
in the place where you plan to place
the vector.
• Mark and drill holes.
• Place the bracket on the wall and secure
it with the fasteners.
Fix the device to the bracket as follows
(Figure 6):
• Place the lower part of the convector onto
the bracket using the special holes located
in the lower part of the convector.
• Slide the upper part of the convector onto
the bracket, fixing it with the latches on the
bracket.
100 mm
min.
100 mm
min.
100 mm
min.
Figure. 5
b
a
Figure. 6
Figure. 7
2. Floor installation
Using the chassis, having previously studied
the mounting scheme (Figure 7), install the
device on the floor:
1. Carefully turn the convector upside down.
2. Take one of the chassis and attach to
the landing area on the right or left side
of the convector so that it fits snugly
against the convector body
3. Secure the chassis using the supplied
mount.
4. Repeat the same procedure for attaching
the second chassis.

Care

The convector does not require any special
maintenance. Before servicing (leaving)
the convector must be disconnected from
the power supply.
The body of the device should be periodically
wiped with a soft, lint-free cloth or damp
sponge. Never use abrasive, foaming
detergents or solvents. It is quite easy to clean
the space behind a wall-mounted heater.
Press down the two latches on the back of
the heater and pull the heater forward. After
it is removed, you can wash the wall on which
it was installed.
After finishing cleaning, put the heater back
in its normal operating position.
Recommended indoor temperature
and humidity:
a) for the convector operation: from -25°С
to + 30°С, humidity from 40% to 90%;
b) for the storage of the convector: from -20°C
to + 80°С, humidity from 40% to 90%.