Table of Contents
Advertisement
Operating the appliance
en
For drying programmes:
Select Intensive Dry or Gentle Dry.
1.
Touch button 5 (Drying) and set
2.
drying time to 15 minutes.
Select Start/Reload A.
3.
End of the programme
– 0 – or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal~ Page 40
If $ (Rinse stop = without final drain/
spin cycle) was selected, press Start/
Reload button to start the final drain/
spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the A
(Start/Reload) button before the spin
cycle starts, then turn the
programme selector to Ú Stop. The
programme is interrupted and the
door lock is released. The laundry
can be removed.
If hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
32
After washing/drying
Open the door and remove the
1.
laundry.
Turn the programme selector to
2.
Ú Stop. The appliance is switched
off.
Turn off the tap.
3.
Not required for Aqua-Stop models.
~ Page 12
Notes
Do not leave any items of laundry in
■
the drum. In the next wash they may
shrink or discolour another item.
Remove any foreign objects from
■
the drum and the rubber seal – risk
of rust.
Leave the detergent drawer and
■
door open so that residual water can
evaporate.
Always remove the laundry.
■
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
When the display panel has gone
■
out at the end of the programme,
energy-saving mode is active. To
activate the display again, select any
button.
Advertisement
Table of Contents
