Table of Contents
Advertisement
1
Operating the
appliance
P reparing the washer dryer
O p e r a t i n g t h e a p p l i a n c e
The washer dryer was tested before
delivery. To remove residual water from
the test procedure, the first wash cycle
should be run without laundry using the
Fluff clean l programme.
Before washing/drying for the first time
~ Page 18
Note:
Never switch on a damaged washer
■
dryer!
Inform your customer service!
■
~ Page 48
Insert mains plug.
1.
Turn the tap on.
2.
The end of the drying programme is
followed by an automatic fluff
cleaning cycle. The tap must be
turned on even when selecting a
drying programme.
Note:
Always provide good ventilation in
■
the room where the washer dryer is
located so that air produced during
the drying phase can be evacuated.
Always keep the inlets and outlets
■
for the cooling air clear.
Open the door.
3.
Operating the appliance
Selecting the programme/
Switching on the appliance
Note:
If you have activated the childproof lock,
you must deactivate it before you can
set a programme.
Select the required programme with the
programme selector. Can be rotated in
either direction.
The washer dryer is switched on.
The following figures are indicated
continuously on the display panel for
the selected programme:
the programme duration (when door
■
is closed),
the preset temperature,
■
the preset spin speed and
■
the maximum load (when door is
■
opened),
...
■
Adjusting the washing
programme
You can use the displayed default
settings or adjust the selected
programme optimally to the laundry
items by changing the default settings
or selecting additional functions. The
selectable settings and additional
functions depend on selected washing/
drying programme.
Overview of programmes~ Page 33
en
27
Advertisement
Table of Contents
