Table of Contents
Advertisement
C L O N E S E T T I N G S
W A R N I N G – C L O N I N G I S N O T
P O S S I B L E
W R O N G S E N S O R T Y P E
P R E S S
E S C
T O E X I T
C L O N E S E T T I N G S
W A R N I N G – C L O N I N G I S N O T
P O S S I B L E
N O S E T T I N G S S A V E D
P R E S S
E S C
T O E X I T
PASSWORD
You can lock the level meter data against unauthorized editing.
After activating the password the data may be read, but can not
be edited. If you try to edit the settings (without true password)
the display shows "NO PASSWORD".
The password can be any 5-digit numeric combination. The com-
bination of numbers 00000 is reserved for disabling the pass-
word.
1.
Use the buttons
and
the password or the mode "CHANGE" for changing the password (when activated, the words are
displayed inversely). Press the button
the password only when the level meter is unlocked. Otherwise, the words "NO PASSWORD"
will be displayed.
2.
Now you can edit the password. The actual edited item is displayed inversely. Press the button
to move to the next position (clockwise direction), button
3.
After the operation is completed, confirm the edited data by pressing the button
B A S I C S E T T I N G S
S E R V I C E
D I A G N O S T I C
C L O N E S E T T I N G S
P A S S W O R D
L A N G U A G E
I N F O
The level meter with activated password will be automatically locked after 5 minutes of inactivity or after
5 min. from switching to measuring mode. Locking of level meter is indicated in the lower left corner
of the screen by the letter "L".
If the password is lost, contact the manufacturer.
21
Incompatible type of level meter. Transfer of the settings can be realized only
with the same type of level meter (e.g. UltraPro 1000–02 → ULM–70-02,
UltraPro 1000–10 → UltraPro 1000–10) and with the firmware version 2.0 and
later.
The data set is not stored into the display module (DM–70). The transfer can
not be done. It is necessary to repeat the procedure of the copying the settings
in the mode "CLONE SETTINGS".
in the menu "PASSWORD" to select the mode "ENTER" for entering
once again to confirm the selection. You can change
Display of status information to confirm data:
P A S S W O R D
"YES" – correctly edited password
E N T E R
"NO" – incorrectly edited password
0 0 0 0 0
"OK" – the password saved (only in case of
"CHANGE")
The password is automatically hidden after it
P A S S W O R D
is edited or changed ("00000" will appear).
C H A N G E
To deactivate the password, edit the nu-
0
0 0 0 0
merical combination "00000" in the mode
"CHANGE".
T E A C H I N G
S E T L E V E L D I S T A N C E :
0 6 0 0 0 m m
S T A R T
N O P A S S W O R D
serves to change the values (0 ... 9).
.
Ultrapro 1000
© Levelpro, s.r.o.
Advertisement
Table of Contents
