Connecting Host Port - Accusys TShare A16T3-Share User Manual

4.5 Connecting Host Port

A16T3-Share supports four Thunderbolt 3 and one PCIe 3.0 host ports, depends on
your plan, you can create multiple arrays for dedicated host or create an array be
visible by all hosts to build a SAN environment,
Follow the steps below to setup a host connection,
1. Connect cable to one of host port.
Note
1. Use valid Thunderbolt 3 cable
2. Connect to SAN port (Z2M, C2M) when connect to PCIe host.
3. The PCIe port can be used for T-Share Expansion by connecting two
A16T3-Share RAID systems. (refer to
2. On RAIDGuardX, create array and select Thunderbolt host port, e.g. plan to build a
SAN, set array can be visible for all host ports.
3. Click Create Array, the new volume shell be recognized by host in seconds.
Note
In first connection, Windows would prompt "New Thunderbolt devices have been
attached", following the instruction and choose "Always Connected".
, or the connection will fail.
Chapter 4.6 T-Share Expansion)