Table of Contents
Advertisement
Loading and Configuring the Device
Driver
In Windows 98, Windows Me, and Windows 2000, the driver is
automatically loaded when you install the DT3120 driver from the
Imaging OMNI CD. Proceed to configuring the device driver,
described on
In Windows XP, however, you must load the device driver, as
described in the next section, before configuring the device driver.
Loading the Device Driver (Windows XP Only)
Once you have installed the DT3120 Device Driver from the Imaging
OMNI CD, installed the board, and powered up the computer, the
Found New Hardware Wizard message appears. Perform the following
steps to load the device driver:
1.
Select the option to Install the software automatically
(Recommended), then click Next.
2.
Click Finish.
The Found New Hardware Wizard message appears for the secondary
device on the DT3120 board.
Select the option to Install the software automatically
3.
(Recommended), then click Next.
4.
Click Finish.
5.
Proceed to the next section to configure the device driver.
Installing the Board and Configuring the Device Driver
page
22.
3
3
3
3
3
3
3
3
3
21
Advertisement
Table of Contents
