Installing The Board; Setting Up The Computer - Data Translation DT3120 Getting Started Manual

Installing the Board

To install the board, you need to set up the computer, select an
expansion slot, then insert the board into the computer, as described
in the following sections.

Setting up the Computer

To prevent electrostatic damage that can occur when handling
electronic equipment, use a ground strap or similar device when
performing this installation procedure.
Perform the following procedure to set up the computer:
1. Turn off the computer.
2. Turn off all peripherals (printer, modem, monitor, and so on)
connected to the computer.
3. Unplug the computer and all peripherals.
4. Remove the cover from you computer. Refer to your computer's
user manual for instructions.
Next, select an expansion slot, as described in the next section.
Installing the Board and Configuring the Device Driver
CAUTION:
3
3
3
3
3
3
3
3
3
17