Chapter 2
Installing the Software
10
To operate properly, the DT3120 board requires the following
software components:
• Microsoft DirectX, version 7.0 or greater,
• DT-Acquire, version 3.2 or greater, and
• Frame Grabber SDK, version 3.0 or greater.
You can install these software components from the Imaging OMNI
CD. To install the DT3120-related software from the Imaging OMNI
CD, perform the following procedure:
1.
Insert the Imaging OMNI CD into your CD-ROM drive.
Note that in most systems, the CD will launch automatically. If
your system does not launch the OMNI CD automatically,
perform the following steps:
a.
Click Start from the Task Bar, then click Run.
The Run dialog box appears.
b. Either enter x:\LAUNCH.EXE (where x is the letter of your
CD-ROM drive) or use the Browse button to locate
LAUNCH.EXE.
Click OK.
c.
The Imaging OMNI CD splash screen appears.
2.
Click Install Products.
3.
Click Mach I Series.
4.
Click Device Drivers.
Click DT3120.
5.
The InstallShield Wizard appears.
6.
Click Next.