Securing Discharge Deflector (33" Decks) - Briggs & Stratton Axion 150Z Series Setup Instructions

Securing Discharge Deflector
(33" Decks)
1. Lift the discharge deflector (A, Figure 10).
2. Remove the wing nut, washer, and carriage bolt from
the two deflector mounting holes in the mower deck.
3. Lower the discharge deflector, and re-install the
removed carriage bolts through the holes in the deck
and deflector, securing with the removed washers and
wing nuts (B). Tighten the hardware securely.
wARNING
Failure to fully secure the discharge deflector can
result in injury or death.
B
Figure 10. Securing the discharge deflector
9
Axion / 150Z Series
A