BrewBuilt X1 UNI Assembly And Instruction Manual page 8

Using Your CoolStix
Your X1+ comes included with a CoolStix and Neoprene jacket. A CoolStix mates
with a cold liquid source such as our BrewBuilt Max 2 or Max 4 Glycol Chiller.
Your CoolStix comes included with quick disconnects that stay sealed when
disconnected to help eliminate messy leaks. NOTE that CoolStix are designed to
help regulate fermentation temperatures but will not lower your beer to cold
crash temperatures (below 40°F) in all situations.
To connect your CoolStix to a Max 2 or Max 4 glycol system use ⅜" ID tubing
and hose clamps. Insert the temperature probe from your Max 2 or Max 4 into
the X1 Thermowell and follow the directions that come with the unit to set the
temperature you wish to keep your X1 conical at.
FAILURE TO FOLLOW INSTRUCTIONS AND WARNING
• Do not pressurize without pressure relief valve in place
• Never open the lid clamp without completely depressurizing your
conical first
• Never open any TC fitting without completely depressurizing your
conical first
• Never remove the Flex Chamber (X1+) without opening the bottom
butterfly valve and completely depressurizing your conical first
• Do not pick up conical when full
™
WARNINGS
CAN LEAD TO INJURY OR DEATH
BREWBUILT.COM
INLET
OUTLET