Advertisement

AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.

Site survey:

1. Carry out a survey of the area where the Snappy will be located, and check for any
overhead/underground cables. It's important that this is carried out to avoid ground
anchors penetrating underground services, and the Snappy coming into contact with
overhead cables when inflated.
2. You should provide an adequate power supply to the fan, this should adhere to your
local power regulations.
3. Check wind speed: It is not allowed to use an inflatable by a higher wind force than
force 5 on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze
when small trees in leaf begin to sway.
Snappy
IMPORTANT
Page 1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Snappy and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for airquee Snappy

  • Page 1 YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT. Site survey: 1. Carry out a survey of the area where the Snappy will be located, and check for any overhead/underground cables. It’s important that this is carried out to avoid ground anchors penetrating underground services, and the Snappy coming into contact with overhead cables when inflated.
  • Page 2 Included with your Snappy: The inflatable Land Operation Fan Timer Box Anchor Pegs in its bag Manual LA0055 FP5005 AP0224 AP0222 Anchor Repair Kit Mattresses 6M Hose Protectors AP0217 AP2998 LA0029 AP0196 Extra equipment needed in addition what is supplied with your inflatable: •...
  • Page 3 Please be aware that this is not a bouncy castle and should not be used for bouncing on. Do not use the product without the side scrim walls of the mouth. Before every play session, just after inflating the slide, please make sure all 4 cam buckle straps (3 interior and 1 exterior) hold the installed hoses tightly.
  • Page 4 The 6m hose directs the airflow through the bed into the chamber beneath the mouth. INFLATION CHAMBER BENEATH THE MOUTH AIR OUTLET, THE END AIR INLET, THE START 3M HOSE OF THE 6M HOSE OF THE 6M HOSE THE HOSES INSIDE THE PRESSURE CHAMBER BENEATH THE MOUTH ARE TIED WITH ACCESS ZIP WEBBING CAM BUCKLE STRAPS...
  • Page 5 The 3M hose inflates the upper parts of the unit. The lower part of the mouth is mounted with the help of a Velcro strip. Place all 4 supplied mattresses around the unit as shown in the figure to the right. Page 5 of 6...
  • Page 6 Airquee reserves the right to change the content of this manual without a prior notice to the customer. The model of your product and the type and number of your inclusions may differ from the one presented in this manual.

Table of Contents