airquee WORLD'S BIGGEST BOUNCY CASTLE Manual

WORLD'S BIGGEST BOUNCY CASTLE

** The following instructions are on addition to the main operation manual supplied

which should be read before the installation and setup of this unit**

IMPORTANT

AS THE OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT

YOUR OWN RISK ASSESSMENTS BEFORE ATTEMPTING TO USE THIS PRODUCT.

Site survey:

1. Carry out a survey of the area where the unit will be located, and check for any

overhead/underground cables or other services. It is important that this is carried out

to avoid ground anchors penetrating underground services, and the unit coming into

contact with overhead cables when inflated.

2. You should provide an adequate power supply to the fans, this should adhere to

your local power regulations. Look at the information label on the blower to see how

much power it uses.

Important:

We recommend to have a generator on site in case of power failure due

to the high number of users allowed onto the unit. Or at least one fan to be powered

from a generator on each part of the unit in case of power failure.

4. Due to the size of this inflatable continuous checks should be carried out to ensure

the safety of users at all times.

Page 1 of 5

Table of Contents

Do you have a question about the WORLD'S BIGGEST BOUNCY CASTLE and is the answer not in the manual?

Page 1 WORLD’S BIGGEST BOUNCY CASTLE ** The following instructions are on addition to the main operation manual supplied which should be read before the installation and setup of this unit** IMPORTANT AS THE OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT YOUR OWN RISK ASSESSMENTS BEFORE ATTEMPTING TO USE THIS PRODUCT.
Page 2 Additional guidance: 1. The number and height of the users allowed is stated on the front of the castle and this must be strictly adhered to. 2. NO one with any pre-existing injuries or health concerns is allowed on the bouncer. 3.
Page 3 fig.1 fig.2 You can start connecting the unit by first attaching only two parts by connecting their small anchors on to each other using the carabiners provided. Then you can continue with other parts until you connect all four parts –see images: Page 3 of 5...
Page 4 After all four parts are connected with the carabiners, please continue connecting the unit with the sandwich Velcro. After the bed is velcroed the walls also need to be connected with Velcro before inflation – see image: Wall of the unit Page 4 of 5...
Page 5 After connecting all four parts together please connect the fans to the unit as described in the Operation Manual provided and start inflation. Anchor the inflatable temporarily to avoid movement during inflation. Once inflated reposition and anchor fully as per the Land Operation Manual guidelines. There are two entrances (fig.1) and two emergency exist (fig.2) on the unit –...