airquee 2 Part Energy Assault Course Additional Operating Instructions

With light pocket

AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT

YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.

Site survey:

1. Carry out a survey of the area where the 2 Part Energy Assault Course will be

located, and check for any overhead/underground cables. It's important that this is

carried out to avoid ground anchors penetrating underground services, and the 2

Part Energy Assault Course coming into contact with overhead cables when

inflated.

2. You should provide an adequate power supply to the fan, this should adhere to

your local power regulations.

3. Check wind speed: The industry recommends a maximum wind speed of Force 5

on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze when

small trees in leaf begin to sway.

Version 1.0 09/08/17

2 Part Energy Assault Course

(with light pocket)

Page 1 of 4

Table of Contents

Do you have a question about the 2 Part Energy Assault Course and is the answer not in the manual?

Page 1 YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT. Site survey: 1. Carry out a survey of the area where the 2 Part Energy Assault Course will be located, and check for any overhead/underground cables. It’s important that this is...
Page 2 Included with your 2 Part Energy Assault Course: The inflatable Land Operation Anchor Pegs Repair Kit in its bag Manual Extra equipment needed in addition what is supplied with your inflatable: • Suitable 240v Power Supply to operate the fan...
Page 3 Number and location of the anchor points: ZIP FOR ACCESSING NO HIGH-LEVEL THE LIGHT POCKET ANCHOR POINTS 16 GROUND ANCHOR POINTS IN TOTAL WIRING HARNESS CONNECTION Set up: Search for the zip covered with a Velcro flap on the top of the unit. Unzip both zips and insert the light in the clear PVC pocket.
Page 4 • In accordance with HSE guidelines all 240v equipment should be protected with an RCD having a maximum trip current of 30 mA. Airquee reserves the right to change the content of this manual without a prior notice to the customer. All the pictures and drawings are for illustration purposes only.