SELFSAT SNIPE PLATINUM User Manual page 9

2. Remote control
Pairing antennas with remote controls
B. BT Setting
i. BT button
a. Press BT button to change to BT setting screen. Press the arrow to move to the desired function
and set with the SET button
b. Press and hold BT button for more than 5 seconds to reset the remote control
SELECT MAC
WP - E9 : FC : E4
PRESS SET
BT SET
REMOVE MAC
PRESS SET
Display window
BT button
Power button
HOME button
SET button
Arrow button
DiSEqC button
Bracket
When use antenna and remote control for the first time or when you delete the
antenna list stored in the remote control, a list of products that can be connected
will appear.
Press the left and right buttons on the remote control to select the MAC Address of
your antenna unit, and press the SET button to connect to the remote control
SNIPE PLATINUM has two MAC addresses, so need to choose exactly according to
the use
WP - XX : XX : XX
WM - XX : XX : XX
W - XX : XX : XX
or
Delete the MAC Address of antenna stored in the remote control.
Used to connect to other products
ENGLISH - 8
A. Sleep mode – battery save mode
i. When not used for more than 50seconds, it
enters the power saving mode.
(When the battery is inserted in the remote
control)
ii. To return from sleep mode, press any button
except DiSEqC button
MAC address of PI BOX of SNIPE PLATINUM
When use antenna and remote control for the first time,
must select a MAC address starting with WP
MAC address starting with WM used for special
operations and should not be selected in general
situations.
For details, refer to [G. Additional function].
W - XX : XX
When using general operations,
it is displayed abbreviated on
the remote control screen