Illusion Esprit 62 Owner's Instructions & Installation Manual page 12

Q u a l i t y & Va l u e I n G a s L o g F i r e s
FITTING THE LOG SET - MODELS EGL62NG, EGL62LP
FITTING THE LOGS & COALS
NOTE THAT THE COALS MUST BE PLACED ONTO THE MESH SUPPORT
DURING INSTALLATION OF THE LOGS AND ARRANGED SO THAT BURNER
DO NOT obstruct any of the burner holes with coals as sooting may occur.
CAUTION: LOGS ARE FRAGILE. PLEASE TAKE CARE WHEN INSTALLING
DO NOT USE EXCESSIVE FORCE OR BREAKAGE MAY RESULT
TIP: Occasionally the mounting holes in the logs can be blocked or malformed during
manufacture. If necessary, drill out log holes with a 6mm drill bit.
Carton contains 6 logs plus 1 bag of 5 ceramic pins. Log numbers are embedded into the
underside of each log.
1. Install log number 1. Hold log at 45º angle with forked end facing right. Insert left end in
rear pin in the burner plate, and then right end in the pin in the rear wall. Log should not
contact rear wall or burner plate when fully inserted.
2. Place log number 2 over right and second from right pins in the burner plate.
The end of log number 2 with a hole in its top should be towards the front of the heater.
This log should not touch the burner plate when fully inserted.
3. Insert ceramic pins in the two holes in the under side of log number 3. Place in right hole
on log number 1 and hole in log number 2.
Log number 3 should contact both logs 1 & 2 when fully inserted.
4. Place ceramic pin in the middle hole of log number 1. Place log number 4 over middle
pin in rear log and right pin in the burner plate.
Note the positions of the bumps in log No. 4.
The narrow end of log number 4 is towards the rear of the heater.
5. Place log number 5 at a 45º angle over the remaining pins in the burner plate.
The chop mark in the log is towards the front of the heater.
6. Insert remaining pins in the rear of log number 6.
Install log number 6, inserting pins in the holes in log number 1 and log number 5.
HOLES ARE NOT BLOCKED.
13
ESPRIT INBUILT MANUAL 2014