Table of Contents
Advertisement
Caution!
Operating in beach range or lift range will cause signifi-
cant loss of maneuverability. Operating in beach range
above idle speed, or for prolonged periods of time, may
cause serious drive damage.
LED display: Certain LEDs display at certain times for the
digital trim instrument:
1
Flashes red within the range above 41.
2
Constant red within the range of 6 to 40.
3
Constant green within the range of 2 to 5.
4
Constant green within the range of 0 to 2.
5
Constant green in trimmed range up to 0.
6
Constant yellow in maximum trimmed position up to 0;
flashes yellow when above 0. (Drive moves, bow is low-
ered.)
7
Constant yellow light within range of 2 to 5; flashes yel-
low when drive moves within trim range and bow is
raised.
Trim/tilt motor protection
Caution!
Always allow the trim/tilt switch to return to its center
position when the drive unit reaches its maximum raised
or lowered position. This precaution will prevent your
trim/tilt motor from overheating.
Impact protection
The trim/tilt system provides impact protection for the drive
unit. If an impact occurs, the drive will "kick up," thereby help-
ing to minimize drive damage. Impact damage, however, can
occur in either FORWARD or REVERSE directions. You must
be careful when
•
You operate in FORWARD or REVERSE
•
You are backing at low speeds
•
You trailer your boat
•
You launch your boat.
Note!
Impact damage is more likely to occur when you
are in a turn where side loads are placed on the
drive unit.
27
Advertisement
Table of Contents
