Assembly - Gravely ZT XL Owner's/Operator's Manual

WARNING: AVOID INJURY. Read and understand
the entire Safety section before proceeding.
Tools Required
• Adjustable wrench
• Petroleum jelly or dielectric grease.
Unpack Unit
Remove unit and all other components from the shipping
container. Engage transmission bypass lever (see on
page 14). Push unit from container onto a level surface.
Disengage transmission bypass lever.
Connect Battery
See Battery Removal and Installation on page 18 and
perform steps 2 and 3 in the installation section.
Place Unit in Operating Position (figure 3):
1. Tip seat back.
2. Secure seat to unit with clamping knob (located in
literature pack).
3. Install steering levers on the handlebar brackets with
mounting hardware.
4. Adjust steering levers (see ADJUSTING STEERING
LEVERS on page 19).
Check Engine Oil Level
Refer to Engine Manual.
Check Tire Pressure
See SPECIFICATIONS on page 25.
Level Mower Deck
See LEVELLING AND ADJUSTING PITCH OF MOWER
DECK on page 15.
Fill Fuel Tanks
See FILLING FUEL TANKS on page 12.
Adjust Seat
See Adjusting Seat on page 11.
Check Safety Interlock System
WARNING: Safety interlock failure and improper
operation of unit can result in death or serious injury.
Check system before each use to make sure it is
functioning properly.
See Safety Interlock System on page 10.
Check function of all controls
See OPERATION on page 10.

ASSEMBLY

4
5
1. Wing Knob
2. Seat
3. Steering Lever
4. Mounting Hardware
GB - 8
1
2
3
5. Handlebar Brackets
Figure 3