Advertisement
Quick Links
18 QT. Fish Fryer With Double Basket Set
Assembly, Use and Care Manual
Model: TF2014501-BA
Tools required:
Phillips screwdriver / Adjustable wrench
To installer or person assembling this appliance: Leave this manual with this
appliance for future reference.
This instruction manual contains important information necessary for the proper
assembly and safe use of the appliance.
Read and follow all warnings and instructions before assembling and using the
appliance.
Follow all warnings and instructions when using the appliance.
Keep this manual for future reference.
This appliance is not for frying turkey.
TF2014501-BA English
Page 1 of 18
For Outdoor Use Only
20190107 V.1
Advertisement
Related Manuals for Rankam TF2014501-BA
Summary of Contents for Rankam TF2014501-BA
- Page 1 18 QT. Fish Fryer With Double Basket Set Assembly, Use and Care Manual For Outdoor Use Only Model: TF2014501-BA Tools required: Phillips screwdriver / Adjustable wrench To installer or person assembling this appliance: Leave this manual with this appliance for future reference.
- Page 2 Do not attempt to extinguish an oil or grease fire with water. Failure to follow these instructions could result in fire, explosion or burn hazard which could cause property damage, personal injury or death. TF2014501-BA English Page 2 of 18 20190107 V.1...
-
Page 3: Prop 65 Warning
Warning: Indicates a potentially hazardous situation which, if not avoided, will result in death or serious injury. CAUTION CAUTION: Indicates a potentially hazardous situation or unsafe practice which, if not avoided, may result in minor or moderate injury. TF2014501-BA English Page 3 of 18 20190107 V.1... - Page 4 Introduction of water or ice from any source into the oil/grease may cause overflow and severe burns from hot oil and water splatter. When frying with oil/grease, all food products MUST be completely thawed and towel dried before being immersed in the fryer. TF2014501-BA English Page 4 of 18 20190107 V.1...
- Page 5 Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to the appliance being put into operation. TF2014501-BA English Page 5 of 18 20190107 V.1...
- Page 6 Never drop food or accessories into hot cooking liquid. Lower food and accessories slowly into the cooking liquid in order to prevent splashing or overflow. When removing food from the appliance care should be taken to avoid burns from hot cooking liquids. TF2014501-BA English Page 6 of 18 20190107 V.1...
- Page 7 Use only tanks equipped with this type of valve. LP tank must be arranged for vapor withdrawal and include collar to protect LP tank valve. TF2014501-BA English Page 7 of 18 20190107 V.1...
- Page 8 Use a clean paint brush and 50/50 soap and water solution. Use mild soap and water. Do not use household cleaning agents. Damage to gas train components can result. Brush soapy solution onto all weld seams and entire valve area. TF2014501-BA English Page 8 of 18 20190107 V.1...
- Page 9 Tighten by hand only – do not use tools. NOTE: If you cannot complete connection, disconnect regulator and repeat step 5 and 6. If you are still unable to complete the connection, do not use this regulator! TF2014501-BA English Page 9 of 18 20190107 V.1...
- Page 10 Customer Service Center at 1-888-837-1380. Use only replacement parts specified by manufacturer. Always close LP tank valve after performing tank test by turning hand wheel clockwise. TF2014501-BA English Page 10 of 18 20190107 V.1...
- Page 11 The replacement hose assembly shall be that specified by the manufacturer. Cleaning and inspection of pressure regulator and hose assembly prior to use. TF2014501-BA English Page 11 of 18 20190107 V.1...
- Page 12 Fig.2. Inspect and clean the burner if needed. Reattach orifice/hose to burner. TF2014501-BA English Page 12 of 18 20190107 V.1...
- Page 13 Burner: Wire brush loose corrosion from burner exterior. Clean clogged gas port holes with an opened paper clip. Replace corroded or damaged burners that would emit excess gas. Cooking surfaces, pots and pans: Clean the cooking surface with soapy water and a nylon cleaning pad. TF2014501-BA English Page 13 of 18 20190107 V.1...
- Page 14 Make sure the alignment pin is seated in the notch on the edge of the burner bracket. Aligned with the burner pins, and secure with the nut (on the threaded pin). TF2014501-BA English Page 14 of 18 20190107 V.1...
- Page 15 DO NOT OVERTIGHTEN. Proper connection is critical for correct operation of unit. 4. Attach the handle by inserting 4 bolts through basket, 4 locking washers and 4 nuts. 5. Attach the hook to the regulator. TF2014501-BA English Page 15 of 18 20190107 V.1...
- Page 16 Prior to lighting, position thermometer clip so that at least 2 3/4” (7 cm) of thermometer tip is submerged in oil. Reposition thermometer as necessary to cook. Continue to use thermometer until burner is turned off. TF2014501-BA English Page 16 of 18 20190107 V.1...
- Page 17 Rust or corrosion is not deemed a manufacturing or materials defect. Discoloration or loss of paint due to handling during assembly, heat or cleaning products. Paint may require touch up. Stainless steel discoloration or corrosion. Consumables such as batteries. TF2014501-BA English Page 17 of 18 20190107 V.1...
- Page 18 Should you encounter any problems, CONTACT US FIRST DO NOT return product to the store! RANKAM (CHINA) MANUFACTURING COMPANY LIMITED 18/F., New Lee Wah Centre, 88 Tokwawan Road, Kowloon, Hong Kong For assistance, contact customer service at customerservice@rankam.com...