Troubleshooting - Polar Electro U636-A Instruction Manual

Telephone Helpline: 1300225960
Cleaning the Condenser Filter
• The condenser is part of the refrigeration system.
The condenser filter requires monthly cleaning.
• Always disconnect power supply before carrying out
Routine Maintenance.
• Failure to clean the condenser filter will reduce the
performance and life of your Polar unit and may
invalidate your warranty
• These models have a removable filter which can be
cleaned with a vacuum cleaner.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is The unit is not switched on
not working
Plug or lead is damaged
Power supply
The appliance Too much ice on the evaporator
turns on, but the
Condenser blocked with dust
temperature is
Doors are not shut properly
too high/low
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in
the appliance
Appliance is overloaded
The appliance is The appliance is not properly levelled
leaking water
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
The appliance is Loose nut/screw
unusually loud
The appliance has not been installed in
a level or stable position
U636-A_U637-A_U638-A_G622-A_A5_v7_20211027.indb 5 U636-A_U637-A_U638-A_G622-A_A5_v7_20211027.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Check power supply
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call POLAR agent or qualified Technician
Empty the drip tray (if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
AU AU
5
2021/10/27 17:04 2021/10/27 17:04