Table of Contents
Advertisement
AU
Installation
Note: If the unit has not been stored
or moved in an upright position, let
it stand upright for approximately
12 hours before operation. If in
doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the shelves
and interior with soapy water.
3. Level the appliance by adjusting the screw
feet.
Fitting the Shelves & Floor Guards
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4. Place the floor guards on the floor of the
cabinet, ensuring the flat side is clear of the
floor.
Note: This is vital for ensuring
correct drainage of condensation.
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
•
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
•
Do not place uncovered hot food or liquid
inside the appliance.
•
Wrap or cover food where possible.
•
Do not obstruct the fans inside the appliance.
•
Avoid opening the doors for prolonged periods
of time.
4
U636-A_U637-A_U638-A_G622-A_A5_v7_20211027.indb 4
U636-A_U637-A_U638-A_G622-A_A5_v7_20211027.indb 4
Telephone Helpline: 1300225960
Turn On
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to [O] and turn
on at the socket.
3. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
Switch off and disconnect from
the power supply before cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must
carry out repairs if required.
Note: Condensation will form in refrigeration
with frequent opening of the doors/drawers
and on hot humid days, please ensure
condensation is allowed to drain properly or
is wiped dry.
2021/10/27 17:04
2021/10/27 17:04
Advertisement
Table of Contents
