Name Of Each Parts - Hitachi SML44 Instruction Manual

MN1-6363 Rev. 1

2-2. Name of each parts

The name of each part is shown in Figure 2 and the explanation for each part is listed in Table 2.
Front mark
Ultrasonic radiation part
Front mark
Probe tip
Cable
Connector
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The probe may malfunction due to cable disconnection.
Do not subject the ultrasonic radiation part to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic radiation part itself is not damaged because the part is made of elastic
material.
Probe tip
Ultrasonic radiation part
Figure 2 Name of each parts
Table 2 Name of each part and its explanation
Name
Ultrasound is radiated from this part. The electronic
linear transducer is integrated underneath this part.
The side of the front mark corresponds to the side of the
front mark on the image.
This part is gripped during operation.
Cable transfers electric input/output signals.
The connector is the part which is connected to the
ultrasound diagnostic instrument.
Cable
Explanation
-4-
Connector