Name Of Each Parts - Hitachi L44LA Instruction Manual

MN1-6013 Rev.4

2-2. Name of each parts

The name of each part is shown in Figure 2 and the explanation for each part is listed in Table 1.
Operating head
Name
Ultrasonic irradiation area
front mark
(direction mark)
Deflection portion
Left-lever,Right-lever
Operating head
Insertion tube
Cable
Connector
Cap
Protect tube
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The probe may malfunction due to cable disconnection
Do not subject the ultrasonic radiation part to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic radiation part itself is not damaged because the part is made of elastic
material.
Right-lever
Left-lever
Connector
Cable
Figure 2 Name of each parts
Table 1 Name of each part and its explanation
This incorporates an electronic linear transducer.
Near the deflection portion corresponds the front mark (direction mark) on
the image display.
When operate the left-lever , you can bend the tip up-down direction.
When operate the right-lever , you can bend the tip left -right direction..
This part is used to operate the deflection portion.
When using the probe, hold this part by hand.
The part is inserted into the patient's body with the ultrasonic irradiation area
and deflection portion.
This cable propagates the ultrasonic signals that are sent and received.
This cable propagates the ultrasonic signals that are sent and received.
The cap eliminates the gap with the probe and keeps airtightness.
Protects the probe from the external tube of torocar.
Deflection portion
Insertion tube
Cap
Explanation
-4-
Ultrasonic irradiation
area
front mark
(direction mark)
Protect tube