Table of Contents
Advertisement
Reversible Door
Instructions
(continued)
or
9. If your refrigerator does not have a Toe
Grille, use a putty knife to remove the
plastic plug (not shown) from front of base
and reinstall in the opposite set of lower
hinge holes. Assemble lower hinge to
cabinet. Install hinge pin in opposite hinge
hole from which it was removed. Install
the washer (some models) on the lower
hinge pin and insert hinge screws, but do
not tighten. Hinges will have to remain
loose against cabinet to align door.
10. Turn center hinge upside down and
secure to cabinet as shown, using the
screws which are in the new holes. Install
refrigerator door on lower hinge pin. Align
door with edge of cabinet. Hold the door
on front of cabinet.
12. Remove plug from upper bearing
of door and reinstall on opposite side.
1 1
11. Place original washer (some models)
over hole in refrigerator door and line up
hole in center hinge. Insert hinge pin
through both holes. Place washer (some
models) on hinge pin, then position
freezer door on center hinge.
Bearing Plug
13. Assemble upper hinge to top of cabinet
and door. Use opposite set of holes. Do not
completely tighten screws.
Align doors so there is a parallel gap
between doors. Adjust doors to cabinet so
gaskets seal but do not bind. Tighten
upper and lower hinge screws.
Additional adjustment may be necessary
after loading the door shelves. Return
food, bottles, and other articles to doors.
Turn the refrigerator control on and
to the previous setting.
Refer to the Instruction Sheet, packed
with the Toe Grille, to replace the Toe
Grille (some models).
Advertisement
Table of Contents
