John Lewis Daisy 803/41404 Quick Start Manual

150cm bedstead

Download this manual

John Lewis

King

Thank you for purchasing this Daisy bed. Please read the instructions carefully before use to ensure

safe and satisfactory operation of this product.

PRE-ASSEMBLY PREPARATION

Please ensure instructions are read in full before attempting to assemble this product.

Necessary Tools

Please check the pack contents before attempting to assemble this product. A full checklist of

components is given in this leaflet. If any components are missing, please contact the John Lewis

Helpline.

This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE

WHEN LIFTING to avoid personal injury and (or) damage to the product.

This product takes approximately 40 MINUTES to assemble with 2 PEOPLE.

The fittings pack contains SMALL PARTS which should be KEPT AWAY FROM YOUNG

CHILDREN.

Read this leaflet in full before commencing assembly.

If you require any additional information or have any issues with this product please call the

John Lewis Helpline on 01244 689949 or e-mail mail@fwgroup-uk.com.

Daisy 150cm Bedstead

1/6

Stock code: 803/41404

For product support or spare parts please call

the John Lewis Helpline;

e-mail: mail@fwgroup-uk.com

Tel: 01244 689949

Page 1 Necessary Tools Please check the pack contents before attempting to assemble this product. A full checklist of components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline. This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE WHEN LIFTING to avoid personal injury and (or) damage to the product.
Page 2 Fittings and parts checklist Parts Fittings...
Page 3 Step by step assembly instructions Step One Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Plastic Spacer (I) and Screw M6 x 25mm (A). Tighten using Allen Key (G). Step Two Place the Tubing Slats (5) into the slots on the Side Rails (3) and secure using Screw M6 x 38mm (B) and Screw Nut (D).
Page 4 Step Three Ensuring the holes along the Centre Rail (4) are facing upwards, attach to the underside of the Tubing Slats (5) using Screw M6 x 63mm (C) and Screw Nut (D). Step Four When attaching the Slats (6), please ensure they have the curved side facing up. Insert the Cap End (E) into the Side Rail (3), then insert a Slat (6) into the Cap End (E).
Page 5 This bed is now ready to use.
Page 6: Care And Maintenance
This product complies with BS EN 1725:1998. If you require any additional information or have any issues with this product please call the John Lewis Helpline on 01244 689949 or e-mail mail@fwgroup-uk.com. John Lewis Partnership 171 Victoria Street, London, SW1E 5NN...