Table of Contents
Advertisement
5. Replace the burner caps onto their
relative crowns; position the pan stands
making sure that the pins of the flame-
spreader crowns are aligned with the
relative seats on the hob (see Chapter
"3.3 Correct positioning of the pan
supports").
If it comes into contact with harsh
detergents, hard water or spills
(cooking water, sauces, coffee,
etc.), clean immediately after
having let the hob cool down.
Flame-spreader crowns
For easier cleaning, the flame-spreader
crowns and the burner caps can be
removed. Wash them in hot water and non-
abrasive detergent. Carefully remove any
encrustation, then wait until they are
perfectly dry. Replace the flame-spreader
crowns, making sure that they are correctly
positioned in their housings with their
respective burner caps.
If the flame of the UR burners is not
stable (burner does not light or is
difficult to light), carefully clean the
perforated crown to remove any
deposits from the holes. If the
problem persists after having
cleaned it, contact your local
Authorised Service Centre.
Cleaning and maintenance
Knobs
The knobs are made of stainless steel and
therefore must be cleaned following the
same instructions as for cleaning the hob.
Igniters and thermocouples
For correct operation the igniters and
thermocouples must always be perfectly
clean. Check them frequently and clean
them with a damp cloth if necessary.
Remove any dry residues with a wooden
toothpick or a needle.
49
Advertisement
Table of Contents
