Table of Contents
Advertisement
Quick Links
OPERATOR'S MANUAL
A Division of Snow Joe
, LLC
®
THANKS
OF A REMANUFACTURED PRODUCT.
To make sure you get the most out of
your product, be sure to register online at
ELECTRIC SNOW THROWER
R
18-INCH | 15-AMP | HALOGEN LIGHT
Model SJ623E-RM
FOR
snowjoe.com
to enjoy full product support.
YOUR
PASTE UPC LABEL HERE
Form No. SJ-SJ623E-RM-880E-V1
PURCHASE
Advertisement
Table of Contents
Related Manuals for SNOWJOE SJ623E-RM
Summary of Contents for SNOWJOE SJ623E-RM
- Page 1 18-INCH | 15-AMP | HALOGEN LIGHT OPERATOR’S MANUAL Model SJ623E-RM A Division of Snow Joe , LLC ® Form No. SJ-SJ623E-RM-880E-V1 THANKS YOUR PURCHASE OF A REMANUFACTURED PRODUCT. To make sure you get the most out of your product, be sure to register online at snowjoe.com...
-
Page 2: General Safety Warnings
OPERATOR’S MANUAL Model SJ623E-RM A Division of Snow Joe , LLC ® Form No. SJ-SJ623E-RM-880E-V1 IMPORTANT! 2. Avoid body contact with earthed or grounded surfaces (i.e. upper and lower water pipes, radiators, ranges, Safety Instructions refrigerators, microwave ovens, and outer frames of heating equipment). -
Page 3: Personal Safety
® ® When stepping backwards, be careful to avoid obstacles center at 1-866-SNOWJOE (1-866-766-9563). beneath your feet or behind you to avoid falling. • Noise control – When using the snow thrower, you must 7. If the snow thrower strikes any object, immediately respect local laws and regulations regarding noise control stop the snow thrower, then inspect for damage –... - Page 4 • Maintain for safety and longevity – Check for misalignment or binding of moving parts, breakage of parts, and any other conditions that may affect the unit’s operation. If damaged, repair or replace the damaged part before use. Use only original replacement parts designed specifically for your model. When replacing any parts, you must strictly observe the instructions and procedures described in this manual.
-
Page 5: Safety Symbols
The STOP seconds after you turn off rotating parts can cause severe the machine. bodily injury. Double insulation. NOTE: The only difference between the SJ622E-RM and SJ623E-RM models is the halogen light system. -
Page 6: Technical Data
120 V ~ 60 Hz Throw Distance (max) 25 ft (7.6 m) Power 15 A Plowing Capacity (max) 720 lbs/min (327 kg/min) Light (Model SJ623E-RM only) 12 V, 20 W halogen Directional Control 180º adjustable chute No Load Speed 2450 rpm Rotor... -
Page 7: Getting Started
Instead, contact the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Handle with care during assembly so that electrical wiring does not become damaged. Getting Started 3. Secure the connection of the middle frame to the upper 1. - Page 8 2. Loosen the screw on the lower chute crank by hand Fig. 6 (Fig. 9). Fig. 9 3. Raise or lower the chute deflector to the desired height of the snow stream and tighten the knob (Fig. 7). NOTE: Do not overtighten the knob. 3.
-
Page 9: Operation
Replace or repair the damaged cord immediately. If you need assistance, contact an authorized Snow Joe + Sun Joe dealer or the ® ® Snow Joe + Sun Joe customer service center at ® ® 1-866-SNOWJOE (1-866-766-9563). -
Page 10: Powering On/Off
(and thus back into your face and onto 4. On the SJ623E-RM model, the halogen light can be used the just cleared path). to illuminate the forward road in the dark. To use the light, turn on the light switch located on the back side of the 6. - Page 11 9. Some parts of the snow thrower may freeze under NOTE: A little lubricant, such as WD-40, will provide a extreme temperature conditions. Do not attempt to smoother operation of the chute (spray at points A and B operate the snow thrower with frozen parts. If the parts as indicated in Fig.
-
Page 12: General Maintenance Tips
1. Detach the worn rubber plate assembly by removing the two sets of nuts and bolts used to secure it to the auger WARNING assembly (Figs. 21 & 22). Make sure that the chute deflector snaps and locks Fig. 21 Rubber plate assembly completely onto the discharge chute. An opening between the discharge chute and the chute deflector may allow foreign objects to be picked up by the snow thrower and thrown in the direction of the... - Page 13 Replacing the Scraper Bar Replacing the Belt + Pulley 1. The scraper bar is located at the base of the snow thrower NOTE: Determine the left and right hand side of the snow beneath the rotor housing (Fig. 24). thrower by standing behind the unit in the normal operating position Fig.
-
Page 14: Service & Support
Service + Support Small pulley If your Snow Joe SJ623E-RM electric snow thrower ® requires service or maintenance, please call 1-866-SNOWJOE Belt (1-866-766-9563) for assistance. Big pulley Model + Serial Numbers 5. Replace the left panel of the snow blower with all screws (Fig. - Page 15 NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at snowjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ®...
- Page 16 We’re here to help Monday through Friday from 9AM to 6PM EST. You can reach us at 1-866-SNOWJOE (1-866-766-9563), online EXCLUSIONS: at snowjoe.com, via email at help@snowjoe.com or tweet us • Wearing parts like belts, augers, chains and tines are @snowjoe.
- Page 17 WARNING! This product or its power cord contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information go to www.P65Warnings.ca.gov. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known [to the State of California] to cause cancer, birth defects, or other reproductive harm.
Need help?
Do you have a question about the SJ623E-RM and is the answer not in the manual?
Questions and answers