Cisco NCS 5700 Series Hardware Installation Manual page 77

Connect Router to the Network
Install and Remove SFP28 and SFP+ Modules
Figure 54: QSFP to SFP+ Adapter
Insert CVR-QSFP-SFP10G in to the QSFP-DD port of the line card, followed by the insertion of the SFP+
pluggable.
Use the show inventory command to get details of the Cisco devices that are installed in the router. The
adapter details are displayed.
Note The CVR-QSFP-SFP10G support is expected in a future release. Therefore, in release 7.3.15 SFP+ modules
can't be used.
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Caution
Protect the line card by inserting a clean SFP+ module cage cover, shown in the figure below, into the optical
module cage when there is no SFP+ module installed.
Figure 55: SFP+ Module Cage Cover
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
71