Cisco NCS 5700 Series Hardware Installation Manual page 85

Connect Router to the Network
Installing the 40-Gigabit QSFP+ or 100-Gigabit Transceiver Module
Figure 63: Installing the 40-Gigabit QSFP+ or 100-Gigabit QSFP28 Transceiver Module (Optical Transceiver Equipped with a Bail-Clasp Latch Shown)
Step 8
Press firmly on the front of the QSFP+ or QSFP28 transceiver module with your thumb to fully seat the transceiver in
the module's transceiver socket (see the below figure).
If the latch is not fully engaged, you might accidentally disconnect the QSFP+ or QSFP28 transceiver module.
Caution
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
79