Safety Instructions - Danfoss ECtemp 330 Installation Manual

ECtemp 330 (+5 to +45°C)
Protection class
Dimensions
Weight
The product complies with the EN/IEC Standard "Automatic
electrical controls for household and similar use":
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
1.2

Safety Instructions

Make sure the mains supply to the thermostat is turned off
before installation.
IMPORTANT: When the thermostat is used to control a
floor heating element in connection with a wooden floor or
similar material, always use a floor sensor and never set the
maximum floor temperature to more than 35°C.
Please also note the following:
• The installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
• The thermostat must be connected to a power supply
via an all-pole disconnection switch.
• The sensor is to be considered as live voltage. Have
this in mind if the sensor must be extended.
Installation Guide
Class II -
86 x 36 x 58mm
83g
5